This page contains information about the Owner’s Manual for the ER-1 from Korg. Korg ER-1 Electribe R Rhythm Synthesizer () Drum machine: 8 voices mix of analog modeling and PCM samples with sequencer and Midi sync. Listen to. Check out the Korg Electribe ER-1 Frequently Asked Questions (FAQ) own Patterns in a Pattern Set see page 31 in the ER-1 owners Manual.
|Published (Last):||14 March 2014|
|PDF File Size:||1.12 Mb|
|ePub File Size:||14.80 Mb|
|Price:||Free* [*Free Regsitration Required]|
Al- ternatively, use the cursor keys to make the parameter select LEDs indicate Position, and rotate the dial or use the select keys to set the position to ” Slightly raise the master volume of the EA-1, and press the Keyboard function key.
Rotate the dial to modify the gate time of that step. Changing the pitch of a step whose trigger is off will have no effect. Page of 52 Go.
Downloads | ELECTRIBE-R mkII – Owner’s Manual | KORG (USA)
If “stuck notes” occur If for some reason a note fails to stop sounding, you can usually switch modes to stop the sound. Never turn off the power while data is being written to memory. Editing a song You can insert a new pattern into a song, or delete an existing pattern. Pitch Offset simply offsets the pitch within the song. The Start message speci- fies when playback will begin.
Recording this type of performance in Song mode is referred to as “event recording. Press the Global mode key to enter Global mode. The pattern num- ber will blink in the display. Press step key 13 once again, and a pattern will be inserted in front of that position.
While the data is being saved, the key will blink. By eer-1 the front panel knobs and keys, you can create analog synthesizer sounds intuitively and easily create phrases using these sounds.
Pattern mode Copying a part Copy Part You electgibe copy the sound settings and rhythm pattern data in- cluding motion sequence from another part to the selected part. If the Stop key is pressed during playback, the master will transmit a Stop message. Press the Pattern or Song key to return to the previous mode.
Metronome settings Metronome oFF, r-0, r-1r-2, on Specify how the metronome will function. Do not use liquid cleaners such as ben- zene or thinner, or cleaning compounds or flammable polishes. The metronome will sound during playback and record ing.
ELECTRIBE-R mkII/Owner’s Manual
The 14 key will blink. When doing this, please turn the Keyboard function key off the key will go dark. Basic operation Quick Start Elrctribe the sound of a part along with a song or pattern 1. Creating A Pattern 4. The display will begin blinking.
electrkbe In the same way as synchronizing the playback from the beginning of the song, you can specify the location at which playback will start, and then playback in electrribe. If you attempt to record additional events, the “memory full” message will appear immediately. Rhythmic C43 Hurry Up!! The data will be copied in a similar way when the pattern length is 2 or 3 refer to the table below.
Part Select section 1.
Korg ELECTRIBER ER-1 Owner’s Manual
During playback, switch between these to hear the difference. Switching patterns When you switch patterns, Program Change and Bank Select messages [Bn, 00, mm] control change 00[Bn, 20, bb] con- trol change 32 mm: Press the Write key once again to eleectribe the data. Data following the inserted pattern will be moved forward. Front and rear panel 2. Use the step keys to input the pitch for each note of the phrase.
A Rhythm Pattern is a sequence of rhythms i. The EG will start when trigger-on occurs the instant you play the keyboard. If this knob is in the center position, the EG will have no effect.